which IP addresses would be assigned to the interfaces …

In the Frame Relay network, which IP addresses would be assigned to the interfaces with point- to-point PVCs? A. DLCI 16 192.168.10.1/24 DLCI 17 192.168.10.1/24 DLCI 99 192.168.10.2/24 DLCI 28 192.168.10.3/24 B. DLCI 16 192.168.10.1 /24 DLCI 17 192.168.11.1/24 DLCI 99 192.168.12.1/24 DLCI 28 192.168.13.1/24 C. DLCI 16 192.168.10.1/24 DLCI 17 192.168.11.1/24 DLCI 99 192.168.10.2/24 […]

Read More

Which of the following statements is true concerning th…

The command frame-relay map ip 10.121.16.8 102 broadcast was entered on the router. Which of the following statements is true concerning this command? A. This command should be executed from the global configuration mode. B. The IP address 10.121.16.8 is the local router port used to forward data. C. 102 is the remote DLCI that […]

Read More

What is the meaning of the term dynamic as displayed in…

Refer to the exhibit. What is the meaning of the term dynamic as displayed in the output of the show frame-relay map command shown? A. The Serial0/0 interface is passing traffic. B. The DLCI 100 was dynamically allocated by the router C. The Serial0/0 interface acquired the IP address of 172.16.3.1 from a DHCP server […]

Read More

which output value indicates to the local router that t…

Users have been complaining that their Frame Relay connection to the corporate site is very slow. The network administrator suspects that the link is overloaded.Based on the partial output of the Router # show frame relay pvc command shown in the graphic, which output value indicates to the local router that traffic sent tothe corporate […]

Read More

Which statement describes DLCI 17?

Refer to the exhibit. Which statement describes DLCI 17? A. DLCI 17 describes the ISDN circuit between R2 and R3. B. DLCI 17 describes a PVC on R2. It cannot be used on R3 or R1. C. DLCI 17 is the Layer 2 address used by R2 to describe a PVC to R3. D. DLCI […]

Read More

which statement is correct?

Refer to the exhibit. The show interfaces serial 0/1 command was issued on the R10-1 router. Based on the output displayed which statement is correct? A. The cable connected to the serial 0/1 interface of the R10-1 router is a DTE cable. B. The R10-1 router can ping the router interface connected to the serial […]

Read More

What is the cause of the problem?

Refer to the exhibit. A technician pastes the configurations in the exhibit into the two new routers shown. Otherwise, the routers are configured with their default configurations. A pingfrom Host1 to Host2 fails, but the technician is able to ping the S0/0 interface of R2 from Host1. The configurations of the hosts have been verified […]

Read More

What does this mean?

The output of the show frame-relay pvc command shows “PVC STATUS = INACTIVE”. What does this mean? A. The PVC is configured correctly and is operating normally, but no data packets have been detected for more than five minutes. B. The PVC is configured correctly, is operating normally, and is no longer actively seeking the […]

Read More