Which two commands can help you to determine what image is running on your industrial switch? (Choose two.) A. show version B. show spanning-tree C. show interface-switch D. show interfaces gigabitEthernet x/y switchport E. show license Show Answer
What is the purpose of a time domain reflectometer? A. It uses pulses to locate and test for sheath faults, damaged conductors, loose connectors, splices, bridge taps, split pairs, and other problems. B. It opens shorts and pinholes in cable shielding. C. It correlates the returned light pulses with a location in the fiber. D. […]
With a Cisco IE 2000 switch, what does a power status LED indicate when it is solid green? A. Power is present on the associated circuit and the system is operating normally. B. Power is present on the associated circuit, but there is no correlation to whether the system is operating normally. C. The system […]
Which parameter would you tune to affect the selection of a static route as a backup, when a dynamic protocol is also being used?
Which parameter would you tune to affect the selection of a static route as a backup, when a dynamicprotocol is also being used? A. hop count B. administrative distance C. link bandwidth D. link delay E. link cost Show Answer
Exhibit: Refer to the exhibit. A technician enters the exhibited commands to configure a new router on the plantfloor, but receives an error message when attempting to save the configuration. What can the technician doto correct the problem? A. Enter the correct command. B. Enter the command at the correct prompt. C. Upgrade the amount […]
Which three pieces of information must be maintained for all stakeholders as part of the change management process?
Which three pieces of information must be maintained for all stakeholders as part of the changemanagement process? (Choose three.) A. the location of the person who applied the change B. the date and time that the change was applied and on which device C. the original change request form that indicates why the change is […]
What is a characteristic of cables that are used in articulating equipment arms? A. fiber-optic zip-cord construction B. shielded copper twisted pair C. high flex rated cable D. type PLTC cable Show Answer
What is the most critical step to perform when you are using optical fiber connectors? A. Cover with dust caps when not in use. B. Immerse in alcohol prior to use. C. Blow off and carefully wipe down with a tissue before and after each use. D. Lightly sand with cloth prior to mating. Show […]
Which two pieces of information are commonly tracked as part of a change management process?(Choose two.) A. reason for the change B. names of people involved in the change C. return on investment related to the change D. SWOT analysis related to the change E. scatter diagrams related to the change Show Answer
What is a reason to use user EXEC mode on an industrial switch? A. to verify commands that you have entered B. to change terminal settings C. to configure VLAN parameters D. to configure parameters that apply to the entire switch Show Answer